HTML datasheet archive (search documentation on electronic components) Search datasheet (1.687.043 components)
Search field

Datasheet: 0556-5338-00 (BEL Fuse)

TOKENRINGNETWORKING COMPONENTS

 

Download: PDF   ZIP
BEL Fuse
defining a degree of excellence
Bel Fuse Inc.
198 Van Vorst Street, Jersey City, NJ 07302 ˇ Tel: 201-432-0463 ˇ Fax: 201-432-9542 ˇ E-Mail: BelFuse@belfuse.com
Website: http://www.belfuse.com
Specifications subject to change without notice.
0556-5338-00
-12
-10
-0.5
-0.8
-1.1
-1.9
-40
-40
-20
-55
-50
-45
S556-5988-00
-16
-9
-0.5
-0.8
-1.1
-1.9
-35
-35
-20
-55
-50
-45
960038A
MECHANICALS
SCHEMATICS
0556-5338-00
S556-5988-00
ˇ Designed for use with Texas Instruments
C380C30/C60 token ring transceivers
ˇ Complies with IEEE 802.5 standards, including low
cutoff frequency
ˇ 2000 Vrms isolation
ˇ Through-hole or surface mount packaging available
ˇ Supports STP 150 ohm or UTP 100 ohm cable
TOKEN RING NETWORKING
COMPONENTS
0556-5338-00
S556-5988-00
ELECTRICALS AT 25ēC
Return Loss
Insertion Loss
Common to Common
Crosstalk
(dB) Min
(dB) Max
Mode Rej (dB) Min
(dB) Min
Part No.
1-17MHz 17-25MHz
4MHz 8MHz 16MHz 24MHz
5MHz 20MHz 200MHz
8MHz 16MHz 24MHz
defining a degree of excellence
Corporate Office
Bel Fuse Inc.
198 Van Vorst Street, Jersey City, NJ 07302-4496
Tel: 201-432-0463
Fax: 201-432-9542
E-Mail: BelFuse@belfuse.com
Internet: http://www.belfuse.com
Far East Office
Bel Fuse Ltd.
8F/8 Luk Hop Street
San Po Kong
Kowloon, Hong Kong
Tel: 852-2328-5515
Fax: 852-2352-3706
European Office
Bel Fuse Europe Ltd.
Preston Technology Management Centre
Marsh Lane, Preston PR1 8UD
Lancashire, U.K.
Tel: 44-1772-556601
Fax: 44-1772-888366
960038A
APPLICATION NOTES
APPLICATION CIRCUIT
TOKEN RING NETWORKING
COMPONENTS
ˇ These Bel token ring networking components have been developed for use with the Texas Instruments C30 integrated
comm processor and transceiver and C60 transceiver only. Both Bel modules provide signal shaping and high voltage
isolation, impedance matching, and EMI and noise suppression for both transmit and receive channels. Both modules
can be used in either 150 ohm STP or 100 ohm UTP media cable environments.
ˇ Suppression of board induced noise can be achieved with precision layout instructions, along with careful consideration
of the selection and placement of discrete components for the interface circuit.
ˇ Do not connect both UTP and STP simultaneously. Only one media connection can be supported at any one time.
ˇ Additional common mode chokes are available for further suppress unwanted signals.
© 2018 • ICSheet
Contact form
Main page